Printing Tips

Check out my printing tips if you're having problems printing to the right size
If you'd like to support this site and all the free things I post- please check out my Don't Eat the Paste Mandala collection coloring book for 9.99 at Amazon.

Tuesday, March 13, 2012

Shampoo Bottle Case- upcycling project

I made this little case from an empty shampoo bottle to hold my shampoo bar for the gym. It's super simple to make!
You will need:

An empty, rinsed out shampoo bottle

  • craft knife
  • 1/2 inch wide elastic
  • needle
  • thread
  • pin -safety or straight pin
Take the cap off your bottle, and cut off the top part, from just under where the shoulders of the bottle start sloping in.
Now cut down the sides, after you've cut off the top, you can switch to strong scissors if it's easier. I think a craft knife is neater. Cut half way down the bottle on both sides, then across to remove the front section.

Flip it to the other side, and cut the flap. You'll want to bring it in past where the sides curve. The top of the flap can be cut however you want. I curved mine.

Cut out slots for the elastic- just over a half inch wide, and spaced at least a 1/4 inch apart.

Thread the elastic through the slots so it goes under the area between the slots and the rest is on the outside of the bottle.


Now close the flap over, and pull the elastic as tight as it needs to be to hold the case closed. Overlap the elastic and pin it, then trim it so there is a half inch overlap. Cut the elastic, and stitch the overlapped elastic closed. 

It's done! Just that easy.

Mine is for the gym, but I'm sure there are lots of other uses for these cases.

No comments:

Post a Comment

Thank you for leaving a comment! Because of the high spam levels and still wanting the site to be friendly, I switched to moderating comments instead of a captcha. As long as you aren't a spammer or spambot this comment will show soon!