Pages

Tuesday, September 28, 2010

Bat Cane- art and instructions




This is my spare cane. I picked up an inexpensive walnut cane from the grocery store to have as a back up, and couldn't resist decoupaging it. 

First I measured the circumference of the cane, which was right about 3 inches. Then I created the design. 5 inches long sounded about right to me. Click on the image to download the full sized 300 ppi version.
I printed that on a decorative paper. My choice was a coffee leaf paper that TerraCycle used to make and that I've been hoarding for special projects. A mottled, marbled, or other light colored design looks good for this. After printing, spray the design with a sealer.
Pull out the glossy Mod Podge. Cut out the design and check to make sure it wraps with the ends just meeting or just barely overlapping. Cover the back of the image with Mod Podge and glue it in place on the cane.
Then I cut strips from some of the remaining decorative paper, and glued them on to decorate, and to finish the edges. 
Cover the whole thing with a light coat of Mod Podge, going beyond the edges a bit to seal the edges. Let dry for a bit, repeat, repeat.
Let the Mod Podge cure for 24 hours, then I added an extra coat of sealer to make it very durable. I used a polyurethane spray because the color of the paper means some yellowing won't mess up the design. I sprayed it, let it dry for 10 minutes, sprayed it again,, let it dry for 10 minutes, sprayed it again. Using a high gloss polyurethane, it's very shiny! Let the polyurethane cure for 24 hours.
End result is a Halloween cane for about 10 dollars. If you don't have polyurethane or Mod Podge, it may cost a little bit more initially, but you'll be able to use them on canes for other holidays or canes to match dressy outfits. 
Other recent projects include this tassel necklace. You can find instructions on Beadwork at BellaOnline.

And these copper projects. The ankhs I made last week. The beaded messy necklace I made last night. They are made in copper and darkened with liver of sulfur. I wiped off the excess with a 3m synthetic steel wool pad. First time I used one, if you click on the image you might be able to see a couple bits of fluff I missed, but compared to regular steel wool on wire projects like this, there was very little shred. The size is a nice one for jewelry projects as well. Tiny little rectangle shaped pads!


1 comment:

  1. I had a request but wanted to send it via email. Whats your address? Thanks Dana
    dlanzalone@sbcglobal.net

    ReplyDelete

Thank you for leaving a comment! Because of the high spam levels and still wanting the site to be friendly, I switched to moderating comments instead of a captcha. As long as you aren't a spammer or spambot this comment will show soon!